|
|
| Specializes in producing general timing belt, ribbed v-belt, v-belt, raw edge belt, flat rubber belt...... |
|
 Product Knowledge: |
 |
General timing belt product knowledge
Precautions on selection and purchase:Surface is clean,belt is free of distortional deformation and belt tooth is plump.In order to prevent sham products,check whether there is a clear "KAIOU" symbol on each product or not.
Problems and precautions on use:
Twisting the belt is strictly prohibited as such an act could damage the belt internally resulting in insufficient tension.
Scuffing of the belt is strictly prohibited as it may damage the belt.
Avoid contact with chemicals (especially acid with strong oxidizing property such as concentrated sulfuric acid)
Avoid long-term contact with oil and water. Precautions on maintenance and replacement:When replacing a timing belt,belt tension must be reduced to the lowest level before the belt is taken out.When a belt is under high tension,prying the belt out with unspecialized tools is strictly prohibited.
Ribbed v-belt product knowledge
Precautions on selection and purchase:select and use suitable specification mode/wedge number belts according to best diameter and wedge slot.
Problems and precautions on product use:
The reason for slipping during product use may be:1,belt is stained with oil or water-this should be cleaned off.2 wrap angle is excessively small-this should be enlarged through changing the position of the back belt wheel.3 belt tension is excessively loose-this should be tightened to product specification.
The reason for appearance of noise in product use may be:1 noise results from slipping.If so ,check and tighten the belt.2 wedge slot is embedded with foreign matter.If so,check whether the protective cover is being used.3 check whether the belt wheel is deflective.If so.the belt wheel must be adjusted to ensure correct alignment.
The reason for appearance of excessive vibration in product use may be:1 belt wheel diameter and belt specification model have been selected and are being used improperly.2wedge has solvent or other chemicals on it.3 belt operating environment temperature is too high.If so,improve cooling method.4 select and use a belt wheel whose slot-top arc radius is qualified i.e. roughness meets he necessary requirements to prevent the belt wheel from rusting.
V-belt product general product knowledge
Precautions on product selection and purchase:select a suitable model and length of belt wheel,select a good brand and pay attention to its brand mark to ensure it is an authentic product.
Problems and precautions on product use:
Reasons for belt slippage:the belt diameter and wrap angle are excessively small: select and use a flexible transmission belt. Belt body is stained with oil stain or water: clean oil stain or wipe water up. Belt tension is too small: enlarge properly. Belt is too long: loosen transmission belt-slipping in the transmission wheel causes the transmission belt wall to be polished and thus lose its grip-the belt must be replaced.
Reason for abnormal noise :Belt wheels are not installed on the same flat face and thus the belt body is un-level resulting in abnormal noise. Check periodically,replace belt if necessary.If a belt has been used for a long time, noise may occur-the belt tension should be checked.
Reason for excessive vibration of the belt: pieces of transmission belts are not uniform in length - the same type of belts should be used.
Reason for appearance of crack in belt: regular appearance of a crack in the lower part of the belt is caused by the fact that the transmission belt surrounds a very small transmission wheel(generally an alternating current generator). The reason for this is that the tension between the two surfaces results in the rubber reaching the point of fracture.In general, smaller irregular cracks indicate that the transmission belt has been used for too long and it should be replaced.
Belt body hardening:the belt body heats up and consequently the belt hardens due to slipping a small change in belt tension may be all that is required,an improved cooling method oruse of a more heat-resistant belt may be required. |
| Hot Products: |
|
|
